Ebay Manifolds starting to pop up

[Kirk]

Just looked and it seems like the 2JZGE manifolds are starting to pop up on ebay... here is a link:

http://cgi.ebay.com/ebaymotors/Turbo-Manifold-2JZGE-TURBO-SC300-IS300-SUPRA-N-A-Setup_W0QQcmdZViewItemQQcategoryZ33742QQitemZ79926 92030QQrdZ1QQsspagenameZWDVW

[Brown Duckz]

Looks good... Kirk did you ever hear anything else on that 1JZ manifold?

[scnat]

we need bean to post pics of the one he just got

[Brown Duckz]

we need bean to post pics of the one he just gotBean spill the beans! :bowrofl:

[SupaSupraSE]

We need someone to be the test dummy(s) of all these new products coming out.

[Bean]

I got one for the GTE motor for a customer of mine

My images that my phone even takes are too large. Of course I have one of the nicer camera phones: RAZR V3 (got it before it got so cheap and everyone and their brother bought one)

Here is a shot of it, notice the bracers. This thing is VERY strong. The GE manifold is slightly different, notice this has no divided flange and the flange points nearly straight, the GE manifold from the above pics is angled to clear the distributor

[Bean]

notice the smooth chamber inside... there is no place it COULD leak!

[Bean]

The collector and the T4 flange. It looks rough inside, but I assure you its not. Its very smooth and obviously cleaned up. Looks a lot better than the older model I had in my possesion at one point and pics of the older ones posted on SF a year or so ago

[Bean]

We need someone to be the test dummy(s) of all these new products coming out.

I'll be the test dummy if I can get assistance on purchasing FMIC piping and a couple other parts (like the turbo :) )

But atm I cant get any loans, will have to save up... wont take long I hope.

[98mkiv]

I have the whole kit, less the manifold. It should be arriving direct from china early next week.

The GTE is a bit rough on the inside, I suspect the GE will be also. Nothing a little die grinding action wont smooth out. I am just running mine as-is I don't think it's worth it to try to smooth out the transitions or welds on the inside. I'd rather leave them intact and as strong as possible since this thing is probably welded together by some 10 year old chained to a welder in china.

-M

[98mkiv]

Anyone near NH who wants to do an install with me Got smoke(s) and heinkens.....!

I am looking to see if anyone else wants to do the install on their car at the same time, it's just easier with two people and two cars to do would be fast. I have the space/tools....

[Brown Duckz]

What turbo are you running?

[98mkiv]

I'm running the turboxs RX7 turbo they sell. I changed the exducer housing from a 1.15 to a .68 AR. I have no map, so I can't tell how far it will go..... I know on the forums, this turbo has been run to 430WHP with minimal tuning. I'd like to see what it can do tuned. I already have my eye on their ball bearing turbo that is like 2x the size, but since it is a drop in replacement, I'm starting with this one then I will make changes later.

-M

[Kirk]

I am going to purchase one of the manifolds for the NA motor and test it out myself...seems like an affordable way to have a 4" intake setup without the distributor getting in the way.

[2jzget]

The manifolds on ebay will not clear the dizzy with a 4 inch inlet