turbosupra
03-26-2007, 02:22 PM
Mark,
There is a gaping hole for Wiggins type clamps that aren't $150 to $200.
I would imagine something could be had/produced/copied/whatever for much less then the cost of the wiggins.
An aluminum v-band setup, that allowed for the flex of the engine would be great too, I have an idea if you want to use it, let me know
It'd also be great if you sold inexpensive stainless and aluminum bends
There is a gaping hole for Wiggins type clamps that aren't $150 to $200.
I would imagine something could be had/produced/copied/whatever for much less then the cost of the wiggins.
An aluminum v-band setup, that allowed for the flex of the engine would be great too, I have an idea if you want to use it, let me know
It'd also be great if you sold inexpensive stainless and aluminum bends