EMU Help its an emergency......im begging on bended kness

[iang]

hi guys i have my install finish and im having problem starting my car, im running stock everything with EMU, 3 bar map sensor. can someone please help me with the jumper settings and the parameter settings for a JDM supra, im begging because im going to a wedding in 3 days and i want my car running for it.....im nearly crying on the pressure any help is appreciated.

thank you in advance

ps. i started this project nov 2008 and im only finish now.
my msn is iangarbino@hotmail.com feel free to msn me to talk me through

[DrNick]

The jumper settings should be fine as defaults with no changes.

One tricky thing with the jumpers is that if you are connecting a water temp input then you need to do the OPPOSITE of what the manual says or your car will overfuel.

I should have a map with JDM parameter specs in it I'll email it to you later.

[iang]

hi drnick thanks for the reply, i got my car started its seems that if i try to connect my ignition wire through the EMU the car wont start, so i just let my standard ecu control my ignition. what am i doing wrong is there more than 2 wires for the ignition?

[sventhemac]

The jumper settings should be fine as defaults with no changes.

One tricky thing with the jumpers is that if you are connecting a water temp input then you need to do the OPPOSITE of what the manual says or your car will overfuel.

I should have a map with JDM parameter specs in it I'll email it to you later.

Dr. Nick, Do you know if the reversing of the temp wires applies to the 1JZ-GTE as well or just the 2J?

[DrNick]

The wiring does not have to be reversed, just the setting of the jumper on the circuit board. I would expect that its the same for the 1JZ as well, but its pretty easy to know if the jumper is set wrong - the AFR at idle will go down to 10 or 11 :)